Axial Fan Installation Basics
Installing an axial fan is like building with LEGOs; the key is stability! Here are the basic steps:
Choose a location: Ensure the installation point is well-ventilated and away from obstacles.
Check accessories: Confirm that the brackets, bolts, and other accessories are complete and undamaged.
Pre-installation test: Before fixing, test whether the fan rotates smoothly.
Mark and position: Use a spirit level to ensure the mounting surface is level.
Special Techniques for Side Wall Installation
Installing the fan on a side wall? This requires a few tricks:
Reinforce the wall: Lightweight walls require additional support plates.
Waterproofing: Seal the wall penetration holes for exterior wall installations.
Angle adjustment: Fine-tune the airflow direction as needed.
Safety distance: Maintain a distance of at least 30cm from the wall.
Solutions to Common Problems
Don't panic if you encounter these problems:
Excessive vibration: Check if the screws are tightened, and add rubber vibration dampeners.
Abnormal noise: This may be due to deformed blades; they need to be corrected or replaced.
Insufficient airflow: Check if the air inlet is blocked.
Motor overheating: Ensure stable voltage and good heat dissipation.



